DIY Burlap Wreath

by - Tuesday, September 25, 2012

It's finally fall ya'll!!!  And that means it's finally time to start putting out cute fall decor!  Here's a cute DIY wreath from Sarah at Belle in the City.  Now - if we could just figure out how to monogram it! ;)

Supplies:
Burlap (I used almost 3 yards)
Wire Hanger
Ribbon
Flowers and/or other decorations (I ended up only using ribbon)
First undo the hanger and bend it until it is a circle
Cut your burlap..what I used was 3 feet long and I cut it into 4 inch strips

Then fold the burlap strips back and forth
Poke the hanger through the strips, pulling the burlap back and forth
Continue that process until the entire hanger is full
and secure it by bending the end pieces around each other
Add a ribbon and/or decoration and hang on your door

 Written by Sarah from Belle in the City

You May Also Like

5 comments

Note: Only a member of this blog may post a comment.